DELLNER WIND SOLUTIONS

K

K

Torsional Force:
40050 Nm

These couplings are for use in application with high dynamic loads. Damping of peak torques and vibrations as well as electrical insulation between motor and gearbox are further reasons for the use of this coupling type. The standard material of the elastic intermediate ring Polyurethane (Vulkollan) is suitable for a temperature range of -35°C up to +80°C. For a short time -40°C up to +100°C.

  • Steel coupling, torsionally elastic and bullet-proof (fail safe)
  • Torque transmission via elastic intermediate ring
  • Replacement of the elastic intermediate ring or the brake disc without moving any equipment
  • Arrangement of the brake drum on the gear side to allow the brake torque to be maintained when the motor is disengaged
  • Vast selection of coupling sizes and brake disc diameters
  • Coupling hubs finish bored and keywayed
  • acc. to DIN 6885
  • Coupling hubs unbored
  • Coupling hubs pilot bored
  • Coupling dynamically balanced according to ISO 21940 Grade: G 2.5; G 6.3
  • Coupling hubs in special lengths
  • Coupling hubs in special material
  • Test certificate DIN EN 10204-3.1

Additional PRODUCTS

Model Number: B4501

Model Number: 148535

Model Number: B6018

Model Number: B4560

Compactus is a pneumatically operated hydraulic pump system that multiplies pneumatic line pressure into hydraulic pressure that is sufficient to operate pressure applied disc brakes at rated capacity.

Model Number: B6384

Model Number: B6011

The DH hydraulic power packs deliver pressure up to 200 bar and can be delivered with optional hydraulic cabinets and electrical terminal boxes.

Model Number: B5566

Model Number: B4342

Model Number: B4810

Our hand pump can be used to simply activate the Dellner brake calipers. It also acts as a back up system for the primary pressure supply system.

Model Number: B4305

Model Number: B6291

Model Number: B4777

Model Number: B6326

Model Number: B7329